Description

DC voltage Sensor Module (0V-25V) – The voltage sensor module is a conventional method used to determine, monitor, and measure the supply of voltage in a device.DC Voltage sensors can sense DC voltages. ADIY DC voltage sensors are highly precise sensors that work on the principle of the potential divider rule. As a result, it reduces the input voltage by a factor of 5. This allows us to use the analog input pin of microcontrollers to observe the voltage above the threshold level. With a small compact device, both voltage and current measurements are combined into a single physical device. For 0-5v analog input, the output measured up to 25v. ADIY dc voltage sensor consists of 5 pins in which two of which are on the two-pin screw terminal and three are male header pins.

Specifications: DC voltage Sensor Module (0V-25V)

1. Divider ratio: 5:1
2. Resistor Tolerance: 1%
3. Max input voltage: 25V
4. Resistor Value: 30K/7.5K Ohm
5. Voltage detection range: DC 0.02445V-25V
6. Voltage Analog Resolution: 0.00489V

Advantages: DC voltage Sensor Module (0V-25V)

• The environment is conducive.
• Plenty of dynamic range.
• Non-satisfactory.
• Increases employee safety.
• Small in weight and size.
• The degree of accuracy is very high.

Features: DC voltage Sensor Module (0V-25V)

1. Output Interface: “+ ” connected 5/3.3V, “-” connected GND, “s” connected Arduino AD pins
2. DC input interface: red terminal positive with VCC, negative with GND
3. You can also use the IICLCD1602 LCD to display voltage.
4. By 3P connector, connect this module with the expansion of board Arduino, not only makes it easier for you to detect voltage battery.

Applications: DC Voltage Sensor Module

• Detects power failure.
• Load sensing.
• Controls the temperature.
• Power demand control.
• Controls electricity demand.
• Safety switching.

Pin Description: DC Voltage Sensor Module

• VCC: Positive terminal of the voltage to be measured (0-25V)
• GND: Negative terminal of the voltage to be measured
• S: Analog Input of Arduino
• + : Not connected (N/C)
• –: GND of Arduino

Package Includes:1× DC voltage Sensor Module (0V-25V)