Tilt Sensor Module SW520D

(Including GST)

TILT SENSOR MODULE with SW520D By ADIY is a device used for knowing the planar movement. Although they are available in various types their basic function remains the same. Their function is to detect the plane shift from horizontal to vertical and sent of a signal when it happens.

The operating voltage of this module is 3.3 to 5 VDC
High sensitivity angle switch SW-520D as sensor
Comparator output, clean signal
Good waveform, strong drive ability, more than 15mA
With a fixed bolt hole, easy to install
Using wide voltage LM393 comparator

80 People watching this product now!

Description

ADIY SW520D TILT SENSOR MODULE is a device used for knowing the planar movement. The tilt Sensor Module for Arduino comes with the basic components for operation. Supplying power and it is good to be used. Attach the inclinometer sensor to an object and it will detect whether the object is tilted. Simple usage as it is the digital output, so you will know whether the object is tilted or not by reading the output. It uses an SW-520D tilt sensor.

The Tilt Sensor is the ball rolling type, NOT Mercury type. The tilt sensor Comes with an M3 mounting hole for ease of attaching it to an object. Onboard, it provides a tilt switch, high sensitivity and commonly being used for tilt detection. The module comes with a power LED and a status LED for the visual indicator

Features & Specifications: SW520D Tilt Sensor Module

Supply voltage: 3.3 V to 5V
Output can be directly connected to the controller
TTL level output
Maximum output current: 15mA
Can work on low voltages
Maximum operating temperature: 0°C to + 80°C
Easy interface
Long life.

Where TILT SENSOR MODULES are Used?

Here are a few cases where SW-520D SENSOR MODULE is chosen:

Case 1: SW-520D is used when the cost of the system cannot be high. SW-520D is one of the cheapest and most robust TILT SENSORS on the market. It is easily available to replace in case of fault.
Case 2: SW-520D is easy to install in the system. All you need to do is power the module appropriately and take the output correctly.
Case 3: With a very long life this module can be used on permanent installments.

TILT SENSOR MODULE INSTRUCTIONS:

The switch output of the module depends on the on and off of the angle swatch. When the angle switch is off, the DO output is high, and when the angle switch is turned on, the DO output is low
The output terminal can be directly connected to the single-chip microcomputer, and the high-low level is detected by the single-chip microcomputer, thereby detecting the angle change. The output terminal can directly drive the relay module, which can form a high-power angle switch to protect the automatic power-off function when the products such as electrical equipment are dumped.

CONNECTING A TILT SENSOR MODULE TO AN ARDUINO

Connecting a till sensor module to an Arduino is a simple process that can be done by following the steps below.
Insert the l with the module on the breadboard or PCB, taking care to align the pins
Connect the sensor module’s power and ground pins to the Arduino board’s power and ground pins.
Connect the US sensor module’s output pin to one of the Arduino board’s digital input pins
Toad the data from the sit sensor module, and upload a sketch or software to the Arduino board. The sketch may utilize the digitalRead() method to read the state of the input pin and calculate the ult
After uploading the program, you can test the tilt sensor module by testing it in different directions and seeing the output on the Arduino.

APPLICATIONS:TILT SENSOR MODULE