Vibration Sensor Module SW180P

Vibration Sensor Module SW180P  – The Tilt Sensor Vibration Alarm Vibration Switch Module for Arduino comes with the basic components for operation. Supplying power and it is good to be used. Attach it to an object and it will detect whether the object is tilted. Simple usage as it is the digital output, so you will know whether the object is tilted or not by reading the output. It uses SW-460D or SW-520D tilt sensor. The Tilt Sensor is the ball rolling type, NOT Mercury type. Comes with an M3 mounting hole for ease of attaching it to an object. On board, it provides a tilt switch and high sensitivity, and commonly being used for tilt detection. The module comes with a power LED and a status LED for the visual indicator. The module will output logic LOW when the module is not tilted until the threshold angle; it will output logic HIGH when it is tilted over the threshold angle. We have tested, the tilt angle is quite big, from 45 degrees to 130 degrees. However, it depends on the angular velocity too. It can be used as a vibration sensor too.

For a variety of vibration triggers, reported Pao alarm, intelligent cars, electronic building blocks, and so on.

Please note that this module in the induction of a small shock when the trigger time will be very short, not enough to drive the relay, some people can directly connect with the relay module data, the actual use of poor results.