5V Relay Module Single Channel (Optocoupler – 5V, 10A)

5V Relay Module with 1 Channel is designed for switching only a single high-powered device from your Arduino. It has a relay rated up to 10A per channel at 250VAC or 30VDC. There are 2 LEDs on the relay module indicating the position of the relay. We have three channels of the relay broken out to screw pin terminals.

The channels are labeled for their function: common (COM), normally closed (NC), and normally open (NO). On the other side of the module, there are three pins – a Ground pin and a VCC pin to power the module, and an input pin IN to control the relay. The input pin is active low, meaning the relay will be activated when you pull the pin LOW, and it will become inactive when you pull the pin HIGH.

Category: RELAY

Description

This 1 channel 5V 10A relay control board module with optocoupler modules by ADIY is compliant with international safety standards, control and load areas isolation trenches it has a single relay a genuine. The inputs of the 1 Channel 5V 10A Relay Module are isolated to protect any delicate control circuitry. The power supply and relay instructions, lit, and a disconnect are off. The input signal, signal, common Terminal and start conducting. It can be used as a single chip module for appliance control and work with both DC or AC signals where you can control the 220V AC load.

A wide range of microcontrollers such as Arduino, AVR, PIC, ARM and so on can control it.

Features : 5V Relay Module Single Channel – ADIY

High impedance controller pin
Pull-down circuit for the avoidance of malfunction
One normally closed contact and one normally open contact
Triode drive, increasing relay coil
Power supply indicator lamp
Control indicator lamp
With 4 fixed screw holes, hole diameter of 3.1mm, convenient installation, and fixation

Useful Link: 5v Relay Module Single Channel

How to use relay module with Arduino Tutorial

Alternate Relay Modules to 5v Relay Module Single Channel

Package Include: 5V Relay Module Single Channel

1 x 1 channel 5V 10A relay control board module with an optocoupler